Stream Chain Matrix Multiplication

This is a kernel containing the cascaded Matrix Multiplication using dataflow. ap_ctrl_chain is enabled for this kernel to showcase how multiple enqueue of Kernel calls can be overlapped to give higher performance. ap_ctrl_chain allow kernel to start processing of next kernel operation before completing the current kernel operation.

KEY CONCEPTS: ap_ctrl_chain, PLRAM

This examples demonstrates how ‘ap_ctrl_chain’ in HLS Kernel can help to improve the performance. In this example matrix multiplication functionality is used to showcase the benefit. Example contains two kernels 1. krnl_chain_mmult: Showcases the Kernel with ‘ap_ctrl_chain’ functionality 2. krnl_simple_mmult: Same kernel without ‘ap_ctrl_chain’

Kernel consists of following sub-blocks 1. mm2s: converts AXIMM data from memory to AXIS data 2. mmult: compute for matrix multplication 2. s2mm: converts AXIS data from compute kernel to AXIMM

ap_ctrl_chain implements a set of block-level control ports to start the design operation, continue operation, and indicate when the design is idle, done, and ready for new input data. The ap_ctrl_chain interface mode is similar to ap_ctrl_hs but provides an additional input signal ap_continue to apply back pressure. Xilinx recommends using the ap_ctrl_chain block-level I/O protocol when chaining Vivado HLS blocks together.

This examples shows the performance difference between the chain kernel and simple kernel.

#pragma HLS INTERFACE s_axilite port = return bundle = control
#pragma HLS INTERFACE ap_ctrl_chain port = return bundle = control

EXCLUDED PLATFORMS

Platforms containing following strings in their names are not supported for this example :

u50
samsung
zc

DESIGN FILES

Application code is located in the src directory. Accelerator binary files will be compiled to the xclbin directory. The xclbin directory is required by the Makefile and its contents will be filled during compilation. A listing of all the files in this example is shown below

src/host.cpp
src/krnl_chain_mmult.cpp
src/krnl_mmult.hpp
src/krnl_simple_mmult.cpp

COMMAND LINE ARGUMENTS

Once the environment has been configured, the application can be executed by

./vadd_mmult <krnl_mmult XCLBIN>