UL3524 Ultra Low Latency Trading

Programming the Device¶

Overview¶

This section provides instructions to program the UL3524 card via the Vivado HW Manager.

Instructions¶

Use the following instructions to program the card via Vivado HW Manager.

Note, ensure that the project has been created and built and .bit file generated. It is recommended to run the HW Manager on a separate machine from the one the card is installed on.

Connect the card via USB (USB0 or USB1) or ADK to the machine running Vivado HW Manager.
Open the Vivado HW Manager by clicking on Open Hardware Manager.
Connect to the device by using Auto Connect
Program the device xcvu2p_0 by right clicking on the device and selecting the Program Device option.
Select the bitstream (.bit) and .ltx generated by the reference design Vivado project as shown in the following image. Typically, these files will be located in the following directory:

./<ref_design_name>/Vivado_Project/<project_name>/<project_name>.runs/impl_1/

Selecting bit file

After the device is successfully programmed, the design can be debugged or validated with any instantiated ILA and VIOs.

Additional information can be found on Vivado Design Suite User Guide: Programming and Debugging (UG908).

Support¶

For additional documentation, please refer to the UL3524 product page and the UL3524 Lounge.

For support, contact your FAE or refer to support resources at: https://support.xilinx.com

^{Terms and Conditions}